EN - 13
Device-specific additional instructions for nailer
.3477
4
Filling the magazine
•
Ensure that nailer and fasteners are compatible (Chap. 1)
with each other.
•
Check fasteners for proper condition.
•
Pull pusher 1 backwards and engage. Insert staple rod into
the magazine from above and push forward. Disengage the
pusher and push it forward
.
5
Adjusting drive-in depth
•
Reduce pneumatic operating pressure as far as possible to
minimize blowback, noise and air consumption (see General
operating instructions).
Mechanical adjustment of drive-in depth:
•
Disconnect the tool from the compressed air supply. Loosen
screw 1 on the release bracket and push release shoe 2
downwards for less recessed clamps or upwards for more
recessed clamps. Then tighten screw 1 firmly again and
connect the tool with compressed air.
6
Removing stuck fasteners from the driving channel
•
Disconnect the tool from the compressed air supply. Remove the
staples from the device. Actuate the locking lever 1 and open the
head piece flap 2. Remove jammed staples. Close the head piece
flap 1 again, connect the tool to the pressure supply and refill the
magazine with staples.
7
EU Declaration of conformity
The BeA GmbH, manufacturer or importer, address as on cover sheet, declares under sole responsibility this product's conformity with all
relevant provisions of the EU Machine Directive 2006/42/EG. The following standards are applied:
EN ISO 12100:2010 (Machine safety); ISO 11148-13:2017-11 (Hand-held non-el. machines - Fastener driving tools);
EN 12549:1999+A1:2008 (Noise measuring for driving tools); ISO 8662 (Vibrations at driving tools).
------------------------------------------
-----------------------------------------------------------
Dr. Jörg Dalhöfer, CEO
Joachim Bauer, Documentation responsible
Summary of Contents for 3477
Page 9: ...9 ...
