Version 2020-17
.3
Technical Data are subject to change without notice!
Page 16 (44)
NEW
KMT COMMUNICATOR
for wireless configuration of a remote MTP
-
NT system via
USB
to the
Bluetooth module
MTP-NT-
BLUE
(incl.
wireless firmware update)
Blue LED
-
Bluetooth connection
Blinking (2Hz) = searching
ON = Bluetooth connected (Please wait always until Bluetooth
connection is established)
Green LED
-
Remote system status
Blinking (2Hz) = searching
ON = contact to remote system (means: remote system power ON)
Slow blinking (0.5 Hz) = Low BATT status at battery on rotating
parts
Micro
-
AB USB Receptacle
for powering and communication to PC
Connected to PC
or
notebook
Rem
ote control for switch ON/OFF battery on rotating part
Press button once (1x) =
ON (LED on BLUE module rotor side is ON)
Press button twice (2x) =
OFF (LED on BLUE module rotor side is blinking)
Switching ON/OFF of KMT communicator:
Press button long (>4 seconds) =
switching the communicator ON/OFF (powering of
communicator with internal 9V Lithium battery)
If the communicator is connected via USB, it is always ON and
doesn’t use the
local Lithium battery
at all
(battery saving).
The battery is a primary cell
(9 V / 1.2 Ah, >5 year
s
shelf life) so
charging of local battery via USB is not possible.
Test of local 9V Lithium battery of communicator:
If the green LED is 3 sec. fa
st
(10
Hz)
bl
inking at start of
communicator, the battery is empty and you must exchange the
Lithium battery!
