25
Changing the heat/cool element
AZURA® CT 2.1 Service Instructions VSM-020
7.4 Installing the new heat/cool element
Note:
Pay attention to the direction of the installation of the heat/cool
element. Ensure that the cooling fins on the left side have a wider spacing
than the fins on the right side. Use the the mounting rails to check the
spacing.
Note:
After the heat/cool element has been changed a manual calibra-
tion as described in chapter 4 has to be performed.
Process
Figure
1.
First insert the temperature
sensor
and the fan of the new
heat/cool element through
the opening.
2.
Attach the black sealing
between heat/cool element
and interior.
3.
Insert the heat/cool element
carefully with little side to
side movements into the ope-
ning. The sealing is slightly
bigger than the opening.
Note:
Do not trap the cables
inside the opening.
Fig. 34
Insert new heat/cool element
4.
Insert the two mountig rails
between the cooling fins and
fasten the 4 screws to the top
plate and the bottom plate of
the device. Keep the direc-
tion of installation in mind.
Apply a little pressure to the
ends of the mounting rails.
5.
If the mounting rails are
installed correctly the left rail
will be concealed by the
cooling fins. The rail on the
right side will still be slightly
visible.
Fig. 35:
Installed mounting rails.
