PIR SETTING (for LANT4 version only)
WARNING
GENERAL
WARRANTY
• Reconnect the front of the luminaire
• Switch on and check for correct operation
• Detection range: up to 10m when mounted at 2.4m height
• Detection angle: 90°
• Time delay: 60sec
This PIR has a manual override function which can be set by the following steps:
1. Turn the switch off and on twice within a 2 second period to enable the manual override setting
2. To reset to standard mode turn the fitting off for a period of 10 seconds and switch back on
This product must be disconnected from the circuit if subjected to any high voltage or insulation
resistance testing. Irreparable damage will occur if this instruction is not followed.
The LEDs fitted in this product are non-replaceable. The unit should be recycled in the correct
manner when it reaches the end of its life. Check local authorities for where facilities exist. Clean
with a soft dry cloth only, do not use aggressive cleaning products or solvents which may damage
the product.
This product has a warranty of 3 years from date of purchase. Failure to install this product in
accordance with the current edition of the IEE Wiring Regulations, improper use, or removal of
the batch codes will invalidate the warranty. If this product should fail within its warranty period it
should be returned to the place of purchase for a free of charge replacement. ML Accessories does
not accept responsibility for any installation costs associated with the replacement product. Your
statutory rights are not affected. ML Accessories reserve the right to alter product specification
without prior notice.
Neutral (blue)
Live (brown)
Fig 2
