Menu operation- Selecting the input source with the remote
1)
Press MENU.
The button lights
in red and the main menu
appears on the screen. If you
don't proceed to step
2
within ten
seconds, the button goes off.
Note:
The menu will not be
displayed if the picture is enlarged
even slightly. In such a case, reduce
the picture size to normal before
starting the menu operation.
2) Press the cursor up or down to
select "SOURCE MENU."
3)
Press L-CLICK. (the button on the remote bottom)
The source menu appears on the screen.
SETTINGS MENU
POWER MENU
IMAGE ADJ MENU
SOURCE MENU
RGB
STANDARD
S-VIDEO
VIDEO
4)
Press the big round cursor up or down to select the desired input source.
5)
Press L-CLICK again. The source you've selected in step 4 will be confirmed, then the
picture from the selected source will be projected on the screen.
6)
Press R-CLICK (the button next to the big round curser key) to turn off the menu display.
Whenever you wish to turn off the menu display, press R-CLICK button.
Menu operation- Selecting the input source with the projector
The menu operation is explained above using the remote control. It can also be controlled with
the projector keypad buttons.
The remote control and unit button comparison table
Remote control buttons
Projector operation buttons
MENU
The main menu appears on the screen when
you press this button.
To turn off any menu
,
press
R-CLICK.
MENU
The main menu appears on the screen when
you press this button.
To turn off any menu, press
R-CLICK
on the
remote control.
Cursor up or down key
Press either key to select the menu item.
SELECT
Each press changes the menu item to the next.
L-CLICK
Press this button whenever confirming
operation is required.
ENTER
Press this button whenever confirming
operation is required.
/- key
Press either key to choose the setting or value
/-
Press either button to choose the setting or
18
