5
Knorr-Bremse Group
PD-203-430
ES1305
Doc. No. Y250906 (EN - Rev. 000)
July 2016
The information contained herein is subject to alteration without notice and therefore may not be the latest release. Please check our website www.knorr-bremseCVS.com for the latest update or contact your local Knorr-Bremse representative.
The figurative mark “K” and the trademarks KNORR and KNORR-BREMSE are registered in the name of Knorr-Bremse AG. Additional terms and conditions apply; please refer to our website knorr-bremseCVS.com for full Disclaimer.
Note: If service work is carried out on a vehicle based on information provided herein, it is the responsibility of the workshop to ensure the vehicle is fully tested and in full
functional order before the vehicle is returned into service. Knorr-Bremse accepts no liability for problems caused as a result of appropriate tests not being carried out.
Copyright © Knorr-Bremse AG - all rights reserved, including industrial property rights applications. Knorr-Bremse AG retains any power of disposal, such as for copying and transferring.
Knorr-Bremse Systeme für Nutzfahrzeuge GmbH . Moosacher Straße 80 . 80809 Munich . Germany . Tel: +49 89 3547-0 . Fax: +49 89 3547-2767 . www.knorr-bremse.com . www.knorr-bremseCVS.com
KB4TA ABS Module
C o m m e r c i a l V e h i c l e S y s t e m s
Stop Lamp Power
The KB4TA module provides a connection for stop lamp power, with an optional connection for a headboard
mounted warning light.
Installation: Stop Lamp Power with External Warning Lamp.
ISO 1185
Pin
Connection
1
Common return
2
Left-hand rear position and end outline marker light and rear registration plate illuminating device
3
Left-hand direction-indicator light
4
Stop lamp
5
Right-hand direction-indicator light
6
Right-hand rear position and end outline marker light and rear registration plate illuminating device
7
Connection “54g” − free
12 11 10
9
8
7
1
4
ISO 1185
X1 - Grey Connector
Note:
A system configured for stop lamp power cannot support 4S/3M system configurations.
Note:
The use of a headboard mounted warning lamp is prohibited on vehicles approved to ECE Regulation 13 unless
national requirements specifically allow the installation.
Y026787: 006: EN: Released: Fri Nov 11 11:18:50 CET 2016:
