5
Knorr-Bremse Group
PD-203-360
Doc. No. Y250908 (EN - Rev. 001)
September 2016
The information contained herein is subject to alteration without notice and therefore may not be the latest release. Please check our website www.knorr-bremseCVS.com for the latest update or contact your local Knorr-Bremse representative.
The figurative mark “K” and the trademarks KNORR and KNORR-BREMSE are registered in the name of Knorr-Bremse AG. Additional terms and conditions apply; please refer to our website knorr-bremseCVS.com for full Disclaimer.
Note: If service work is carried out on a vehicle based on information provided herein, it is the responsibility of the workshop to ensure the vehicle is fully tested and in full
functional order before the vehicle is returned into service. Knorr-Bremse accepts no liability for problems caused as a result of appropriate tests not being carried out.
Copyright © Knorr-Bremse AG - all rights reserved, including industrial property rights applications. Knorr-Bremse AG retains any power of disposal, such as for copying and transferring.
Knorr-Bremse Systeme für Nutzfahrzeuge GmbH . Moosacher Straße 80 . 80809 Munich . Germany . Tel: +49 89 3547-0 . Fax: +49 89 3547-2767 . www.knorr-bremse.com . www.knorr-bremseCVS.com
KB4TA/KB4TA D System Components
C o m m e r c i a l V e h i c l e S y s t e m s
Trailer Data Plate
S
l
Feder-Nr
Spring No
Ressort No
bar
Automatisch-Lastabhängige Bremskraftregeleinrichtung (ALB)
für Typ:
Load Sensing Device for Type:
Dispositif de correction automatique de freinage pour type:
Ventile Nr
Valves No
Valves No
Ausgangsdruck
Output Pressure
Pression de sortie
bar
Weg s am Hebel
Stroke s at Lever
Course s ou Levier
mm
KNORR- BREMSE AG
mm
l=
S
l
mm
l=
Achslast
Axle Load
Charge essieu
kg
Ausgangsdruck
Output Pressure
Pression de sortie
bar
Weg s am Hebel
Stroke s at Lever
Course s ou Levier
mm
Achslast
Axle Load
Charge essieu
kg
Eingangsdruck
Input Pressure
Pression de entrée
Vorderachse, Front Axle, Essieu avant
Feder-Nr
Spring No
Ressort No
Ventile Nr
Valves No
Valves No
Hinterachse, Rear Axle, Essieu arrière
VF 00075/31
emergency features, and with static or dynamic operation.
A static valve uses the load sensing ratio at the point of
brake application which remains constant throughout the
brake application while a dynamic valve continually adjusts
the load sensing ratio throughout the brake application
and therefore takes account of any load transfer.
A trailer mounted data plate, showing the settings of the
load sensing valve is required by ECE Regulation 13 and
Directive 71/320/EEC.
Technical Data:
• Maximum operation pressure: . . . . . . . 8,5 bar
• Operating temperature range: . . . -40 °C to +80 °C
Y026787: 006: EN: Released: Fri Nov 11 11:18:50 CET 2016:
