TEMON 4-C
Doc. N°
MO-0368-ING
Microener. - Copyright 2010
2.1
Date
01.12.2008
Rev.
0
Pag.
13
of
14
12. Visualization of the Maximum Measured Value of Temperature
Pressing the
Tmax
key on displays appear, in modality flashing, the maximum measured value of temperature. To
pass from the visualization of the maximum temperature T1-T3 to T2-T4 to use
and
keys. After an interval of
about 8 seconds without to press any key the device come back to display the value of measured temperature.
To reset the v
alue of the maximum temperature it’s necessary to go in the visualization maximum values and after
to press at the same time Tmax and
.
13. Visualization of the Channels With the Higher Temperature
Press the
HOT
key for same second up to switch on the HOT led.
On the left display of the front panel will appear the temperature of the measure channel hotter between the inputs
1 and 2.
On the right display on the front panel will appear the temperature of the measure channel hotter between the
inputs 3 and 4.
To come back in the standard modality of measure visualization press the HOT key for some second up to switch
off the relative led of signalling.
14. Test of the Light Signalling
Press at the same time
and
keys: all of the light signalling will start to flash for some seconds.
15. Visualization of the Measured Temperature
On the display on the left of the front panel appears the temperature of the channels T1 T2 in the range
0°C ÷ +220°C.
On the display on the right on the front panel appears the temperature of the channel T3 T4 in the range
0°C ÷ +220°C.
Use
and
keys to change the measure channels displayed.
16. Exclusion of the Probe Inputs Not Used
If one or more inputs are not used, it’s need to connect a resistance of value included between 100 and 120 ohm,
0.25W.
In the figure is showed the connection to disable the input Ch1. The same connection can be used also for the
other inputs.
Ch1
1
2
3
R = 100 ÷ 120 ohm
0,25W
