OPERATING CONTROLS
6
For operator safety, before operating the machine, make
certain that dust intake hose is always attached to the dust
intake port. The rotating fan located inside the blower housing
is accessible through the dust intake port and can
be hazardous.
Always wear proper apparel. Do not wear jewelry and keep
fingers and all foreign objects out of the dust intake port.
Follow the safety rules earlier in this manual.
The on/off switch is located on the side of the motor.
To turn the dust collector “ON”, push switch upward.
To turn dust collector “OFF”, push switch downward.
ON/OFF SWITCH
NOTE : Before any maintenance or service is performed, be
sure the dust collector is disconnected from the power source
to prevent accidental starting and the safety gates closed.
All maintenance other than the items recommended in this
manual should be performed by an authorized Service Center.
1. IMPORTANT : Always disconnect the machine from the
power source before performing any maintenance
procedures.
2. The condition of the dust bag should be checked
periodically for damage and emptied on a regular basis.
Do not transport the machine with a full dust bag.
3. Clean and apply a dry silicone lubricant monmthly
to the impeller to remove any dirt or build-up of pitch,
gum and wood shavings
Removing dust and dirt : Blow off motor with low pressure
air to remove dust or dirt. Air pressure above 50 P.S.I.
should not be used as high pressure may damage insulation
and blow dirt under loosened tape. The operate peforming
this cleaning function should always wear eye protective
goggles. Dusk can cause excessive insulation temperatures.
MAINTENANCE
MOTOR MAINTENANCE
WIRING DIAGRAM
120 volt
240 volt
Black 3
White 1
Red 4
Yellow 2
Black 3
White 1
Red 4
Yellow 2
PARTS LIST
Specification
Q’ty.
Part No.
D e s c r i p t i o n
16 Handle
1
17
Handle cap
5/8”
2
18
Phillip head screw
5/16” x 1”
2
19 Sponge
1
20
Supporting leg
2
21
Hex. head screw
5/16” x 12”
12
22 Supporter
1
23 Hanger
1
24
Upper filter bag
1
25
Bottom collecting bag
1
26
Power cord
1
27 Switch
1
28
Open end wrench
10 - 12 mm
1
29
Washer
5/16” x 18
4
Specification
Q’ty.
Part No.
D e s c r i p t i o n
1 Base
1
2
Caster
5/16”
4
3
Nut
5/16”
4
4
Collector body
1
5
Hex. head screw
M6 x 20
1
6
Impeller washer
1
7 Impeller
1
8
Hex. head screw
5/16” x 5/16”
1
9
Hex. head screw
1/4” x 1/2”
4
10
Washer
1/4” x 25
4
11
Inlet cover
1
12
Hex. head screw
M5 x 10
12
13
Motor packing
1
14 Key
1
15
Motor
1