Dimming actuator
Power consumption 230 V per output
Incandescent lamps
20 ... 250 W
HV halogen lamps
20 ... 250 W
HV-LED lamps
typ. 3 ... 50 W
Compact fl lamp.
typ. 3 ... 50 W
Inductive transformers
20 ... 250 VA
Inductive transformers with LV-LED
20 ... 100 VA
Inductive transformers
20 ... 250 VA
Electronic transformers with LV-LED
20 ... 100 W
Inductive capacitive mixed load is not permitted.
With setting "LED trailing edge phase control" the connection power for HV-LED lamps
and electronic transformers with LV-LED doubles.
Power consumption 110 V per output
Incandescent lamps
20 ... 120 W
Incandescent lamps
20 ... 120 W
HV halogen lamps
20 ... 120 W
HV-LED lamps
typ. 3 ... 24 W
Compact fl lamp.
typ. 3 ... 24 W
Inductive transformers with LV-LED
20 ... 50 VA
Electronic transformers
20 ... 120 W
Electronic transformers with LV-LED
20 ... 50 W
Inductive capacitive mixed load is not permitted.
With setting "LED trailing edge phase control" the connection power for HV-LED lamps
and electronic transformers with LV-LED doubles.
Power boosters
See power booster instructions
Connection
single stranded
0.5 ... 4 mm²
Finely stranded without conductor sleeve
0.5 ... 4 mm²
Finely stranded with conductor sleeve
0.5 ... 2.5 mm²
Fitting width
144 mm / 8 module
KNX
KNX medium
TP256
Commissioning mode
S-mode
Rated voltage KNX
DC 21 ... 32 V SELV
Current consumption KNX
15 mA
Connection mode KNX
device connection terminal
6.2 Troubleshooting
Connected LED lamps or compact fluorescent lamps switch off in the lowest dimming position
or flicker
The set minimum brightness is too low.
Increase minimum brightness.
Connected LED lamps or compact fluorescent lamps flicker
Cause 1: Lamps are not dimmable.
13 / 16
32575362
10867485
04.12.2019
