Cause 2: Manual control via bus disabled.
Enable manual control.
Output cannot be operated.
Cause: Output is disabled.
Cancel disabling.
None of the outputs can be operated.
Cause 1: All of the outputs are disabled-
Cancel disabling.
Cause 2: Continuous manual mode active.
Deactivate manual mode (switch off continuous manual mode).
Cause 3: Application software has been stopped, programming LED is flashing.
Perform reset: Disconnect device from bus, switch on again after 5 seconds.
Cause 4: Application software missing or faulty.
Check programming and correct.
Blind/shutter outputs cannot be operated
Cause: Forced position, safety function or sun protection is active.
As long as higher-order functions are active for a blind/shutter output, this output cannot be
operated.
Position runs and scene runs are not executed or executed improperly
Cause 1: Sun protection, safety function, forced position or manual mode is activated.
As long as higher-order functions are active, no position or scene runs are possible.
Hanging does not move to end position, position and scene runs faulty.
Cause: Blind/shutter travelling time has been set incorrectly.
Correct blind/shutter travelling time.
The hanging moves upwards before the positioning and scene run.
Cause: No position saved, e.g. due to power failure.
Hanging performs reference run. Do not interrupt hanging run.
6.3 Accessories
Connection cover
Art. No. 2050 K
Decoupling relay
Art. No. TR-S
Decoupling relay for rail mounting
Art. No. TR-S REG
Decoupling relay, flush-mounted
Art. No. TR-S UP
6.4 Warranty
We reserve the right to make technical and formal changes to the product in the interest of
technical progress.
We provide a warranty as provided for by law.
Please send the device with a description of the defect to our central customer service office.
10/11
82560023
J:0082560023
05.08.2013
Switch actuator / blinds actuator
