Priorities for blinds operation
-
Highest priority: manual mode
-
2nd priority: forced position
-
3rd priority: safety function
-
4th priority: sun protection
-
Lowest priority: bus mode: moving up/down, slat positioning, scenes, positioning
Switching on the temporary manual control
Operation using the button field is programmed and not disabled.
o
Press the
c
button briefly.
Status-LET
A1
flashes, LED
c
remains off.
i
After 5 seconds without a button-press, the actuator returns automatically to bus operation.
Switching off temporary manual operation
The device is in short-term manual mode.
o
No button-press for 5 seconds.
- or -
o
Press
c
button briefly as many time as necessary until the actuator leaves the short-time
manual mode.
Status LEDs
A1...
no longer flash, but rather indicate the output status.
Switching outputs: depending on the programming, the output relays switch to the position
that is active after the manual mode is switched off, e.g. to the forced position, logic
function.
Blind/shutter outputs: depending on the programming, the hangings move to the position
that is active after the manual mode is switched off, e.g. to the forced position, safety or
sun protection position.
Switching on permanent manual control
Operation using the button field is programmed and not disabled.
o
Press the
c
button for at least 5 seconds.
LED
c
is illuminated, status LED
A1
flashes, continuous manual mode is switched on.
Switching off permanent manual control
The device is in continuous manual mode.
o
Press the
c
button for at least 5 seconds.
LED
c
is off, bus operation is switched on.
Switching outputs: depending on the programming, the output relays switch to the position
that is active after the manual mode is switched off, e.g. to the forced position, logic
function.
Blind/shutter outputs: depending on the programming, the hangings move to the position
that is active after the manual mode is switched off, e.g. to the forced position, safety or
sun protection position.
Operating the outputs
The device is in continuous or short-term manual mode.
o
Press
c
button briefly as many times as necessary until the desired output is selected.
The status LED of the selected output
A1...
flashes.
The LEDs
ON/
n
and
OFF/
o
indicate the status.
o
Operate output with
ON/
n
or
OFF/
o
button.
Switching outputs: switch on or switch off.
Blind/shutter outputs:
Short: Stop hanging.
Long: Move hanging upwards/downwards.
The selected output executes the corresponding commands.
The LEDs
ON/
n
and
OFF/
o
indicate the status.
4/11
82560023
J:0082560023
05.08.2013
Switch actuator / blinds actuator
