i
Short-term manual operation: After running through all of the outputs the device exits
manual mode after another brief press.
Switching off all outputs / Stopping all hangings
The device is in continuous manual mode.
o
Press the
ALL OFF
button.
All outputs switch off; all hangings stop moving.
Disabling individual outputs
The device is in continuous manual mode.
o
Press
c
button briefly as many times as necessary until the desired output is selected.
The status LED of the selected output
A1...
flashes.
o
Press
ON/
n
and
OFF/
o
buttons simultaneously for at least 5 seconds.
Selected output is disabled.
The status LED of the selected output
A1...
flashes quickly.
o
Activate bus mode (see section Deactivating permanent manual control).
i
A disabled output can be operated in manual mode.
i
When a disabled output is selected in manual mode, the corresponding status LED flashes
twice briefly at intervals.
Re-enabling outputs
The device is in continuous manual mode.
o
Press
c
button briefly as many times as necessary until the desired output is selected.
The status LED of the selected output
A1...
flashes twice briefly at time intervals.
o
Press
ON/
n
and
OFF/
o
buttons simultaneously for at least 5 seconds.
Selected output is enabled.
LED of the selected output flashes slowly.
o
Activate bus mode (see section Deactivating permanent manual control).
5 Information for electrically skilled persons
5.1 Fitting and electrical connection
DANGER!
Electrical shock when live parts are touched.
Electrical shocks can be fatal.
Before working on the device, disconnect the power supply and cover up live
parts in the working environment.
Fitting the device
Observe the temperature range. Ensure adequate cooling.
o
Snap device onto DIN rail to DIN EN 60715. Output terminals must be at the top.
5/11
82560023
J:0082560023
05.08.2013
Switch actuator / blinds actuator
