26
Changing Model Memory
(Model Select)
After switching the power on, press the
Up key until the Model Select screen is
called up from the Initial Screen.
It also can be displayed
in the order of Direct to
Down keys. (Direct
Mode)
Use the +/- keys to select the model
number. Can select between 1 and 0
•The position of each Et will stored when
the power of the model or the model
memory is switched off.
Be sure to use the Model Select after you
fully understand the functions. Incorrect
operation may cause the model to run out
of control.
Caution!
When the model memory is in use, be
careful that the position will be stored in
the memory if you change the model
memory after moving the Et level or
trims.
Caution!
Advice
Advice
This transmitter can store all settings for up to 10 models, and this
function is used to switch models among these settings.
Level 1 : Model Select