SAFETY INFORMATION
• Use the power tool in daylight or in good artificial light.
• To avoid accidental start-ups, remain in the starting position when turning the power tool on. The
operator and the power tool must be in a stable position during start-up. See the section titled
Starting/Stopping Instructions.
• Use this power tool only for the purposes it was designed.
• Hold the power tool with both hands while it is in use. Keep a firm grip on the handles.
• If the impeller does not rotate freely due to ice, thaw the power tool thoroughly before attempting to
use it.
• Keep the impeller clear of debris.
• Do not attempt to clear the impeller while the motor is running.
• After striking a foreign object, turn the power tool off and remove the battery pack, then inspect it for
damage. Repair any damage before restarting and using the power tool.
• If the power tool starts to vibrate abnormally, stop the power tool immediately and attempt to
determine the cause. Vibration is generally an indication of danger.
• Stop the motor and remove the battery pack whenever the operator is not in the operating position,
before unclogging the impeller, and before making any repairs, adjustments, or inspections.
• Do not use on graveled surface unless the power tool is adjusted for such a surface in accordance
with the operator’s manual.
• Keep Children Away – All visitors should be kept a safe distance from work area.
• Dress Properly – Do not wear loose clothing or jewelry. They can be caught in moving parts.
• Wear rubber boots when operating the power tool. Do not operate the equipment when barefoot or
wearing open sandals. Always wear substantial footwear.
• Operation of the power tool in the hand-held position is unsafe, except in accordance with the
special instructions for such use provided in the operator’s manual.
• Keep guards in place and in working order.
• Don’t Force Power Tool – It will perform better and safer at the rate for which it was designed.
• Don’t Overreach – Keep proper footing and balance at all times.
• If the power tool strikes a foreign object, follow these steps:
i) Stop the power tool.
ii) Inspect for damage.
iii) Repair any damage before restarting and operating the power tool.
• Store Idle Power Tool Indoors – When not in use, power tools should be stored indoors in dry,
locked-up place out of reach of children.
• Maintain Power Tools With Care – Follow instructions for lubricating and changing accessories.
• Allow the power tool to run for a few minutes after clearing snow in order to prevent moving parts
from freezing.
• Only use identical replacement parts and accessories for this power tool. The use of nonidentical
parts or accessories could lead to serious injury to the user or damage the power tool, and will void
the warranty.
• Do not pick up the power tool while it is running. The power tool is designed to travel along the
ground.
• Never allow children to operate a power tool. Keep the area of operation clear of all persons,
particularly small children, and pets.
• Thoroughly inspect the area where the equipment is to be used and remove all stones, sticks,
wires, bones, and other foreign objects.
• Stop the blade(s) when crossing gravel drives, walks, or roads.
• Use only 80-volt Kobalt batteries.
7
