Kobalt 1332912, Manual

9

OPERATING INSTRUCTIONS

1.  To Attach Battery Pack

a.  Align the raised portion on the battery pack 

with the grooves on the bottom of the tool, 

then slide the battery pack onto the tool, as 

shown.

b.  Make sure that the latches on the battery 

pack snap into place and the battery pack is 

secured to the tool before beginning operation. 

NOTICE:

 When placing the battery pack on the 

tool, be sure that the raised rib on the battery pack 

aligns with the groove on the tool and the latches 

snap into place properly. Improper assembly of 

the battery pack can cause damage to internal 

components.

To Detach Battery Pack

a.  Press the battery-release buttons to release the battery pack.
b.  Pull backward on the battery pack to remove it from the tool. 

 WARNING:

Battery tools are always in operating condition. Therefore, always remove the 

battery pack when the tool is not in use or when carrying the angle impact wrench at your side.

2.   Direction-of-Rotation Selector (Forward/

Center Lock/Reverse)

The direction of anvil rotation is reversible and is 

controlled by a selector (B) located near the trigger 

switch (C). With the angle impact wrench held in 

the normal operating position, pointing away from 

you:
a.  Position the direction-of-rotation selector (B) to 

the left of the tool for forward rotation.

b.  Position the direction-of-rotation selector to the 

right of the tool for reverse rotation.

c.  Setting the selector in the center (lock) position 

helps reduce the possibility of accidental 

starting when not in use.

NOTICE:

 To prevent gear damage, always allow the impact wrench to come to a complete 

stop before changing the direction of rotation.

NOTICE:

 The impact wrench will not run unless the direction-of-rotation selector is engaged 

fully to the left or right.

1

Battery-release 

button

2

Forward Reverse

B