35
INSTRUCCIONES DE FUNCIONAMIENTO
g. Asegúrese de que la flecha de rotación del disco de corte y la flecha del protector del
disco apunten en la misma dirección. Vuelva a colocar el disco de corte (H) entre la
protección (I) y el suministro de agua, contra la arandela interior (Fig. 2b).
h. Vuelva a colocar la arandela externa (Q). Alinee la arandela externa con el vástago del
husillo hasta que encaje (Fig. 2b).
i. Reemplace el perno para rueda (R) (Fig. 2b).
j. Mantenga fija la arandela externa (Q) con la llave plana (D) (Fig. 2a).
k. Apriete firmemente el perno para rueda girándolo EN DIRECCIÓN CONTRARIA A LAS
MANECILLAS DEL RELOJ con la llave en T (P) (Fig. 2a).
2b
R
I
Q
H
Flecha de rotación
Vástago
del husillo
Arandela
interna
Suministro
de agua
P
D
AVISO:
• No apriete el perno para rueda en exceso (R).
• Nunca use un disco de corte demasiado grueso
para dejar que la arandela externa se engrane
con la sección plana del husillo.
• Después de instalar la hoja de sierra, coloque
la llave en T (P) y la llave plana (D) en sus
ubicaciones de almacenamiento específicas.
• Para evitar que la llave plana (D) se caiga
durante el funcionamiento, la característica
elevada de la llave plana debe quedar hacia
arriba (Fig. 2c).
• Hay un bloque de goma de sujeción en la ranura
de almacenamiento de la llave en T. Cuando
guarde la llave (P), presiónela firmemente en su
lugar.
2c
D
P
Característica
elevada
Summary of Contents for 4963560
