ASSEMBLY INSTRUCTIONS
10
2
3
1
1. Remove the air inlet protective cap from the
air inlet (G) (See Figure 1).
3. Insert a male plug (not provided) by hand into
the air inlet (G) (See Figure 2).
4. Place 2-3 drops of air tool oil (not provided)
into the male plug before each use (See
Figure 3).
Use threaded sealant tape (not included) on the
threading of the male plug. Once sealant
tape is properly in place, tighten male plug
turning clockwise with a wrench (not included)
for air tight connection.
DO NOT OVERTIGHTEN.
2.
