CARE AND MAINTENANCE
11
CLEANING YOUR HOPPER GUN
1. Use water to fill and then clean out the hopper. Then reconnect to the air
compressor and blow air through to remove any remaining debris.
2. Make sure the valve is open if you use an air shut-off valve.
3. Turn the hopper gun upside down and lubricate with household oil by
dropping oil in the quick disconnect (with the air shut-off valve in th e open
position). This lubricates the air stem and O-rings.
4. Pull the trigger several times and close the shut-off valve.
ASSEMBLING AND DISASSEMBLING YOUR HOPPER GUN
Taking Your Hopper Gun Apart
1. Take out the material orifice by turning the nut counterclockwise.
2. Remove the knurled knob by turning it counterclockwise until it comes out.
3. Using your finger push the center stem out of the gun through the rear.
TO REASSEMBLE:
1. Before you put the hopper gun back
together wipe a small amount of
lithium-based grease on the O-ri ngs of
the adjustable stop assembly.
2. Replace the center stem from the rear.
Make sure not to tear up the O-rings when
reassembling.
3. Replace the knurled knob by turning it
clockwise.
4. Put in your material orifice and secure
turning the nut clockwise.
Long Term Storage:
Make sure to store in dry secure location.
