4-66
［
1
4
3.
Clean the area around oil filler cap (1), remove the
cap and loosen drain cock (2) of the engine oil pan
to drain the oil.
4.
After draining the oil, tighten drain cock (2) and oil
filler cap (1) securely.
3
5.
Turn filter element (3) with a filter wrench and
remove it.
6.
Remove dirt and foreign materials from the
mounting surface of the oil filter body.
5
7.
Apply engine oil to the gasket of new filter element
and install the filter element by turning it by hand
until it does not turn any more.
• Do not reuse the filter element, O-ring and gasket.
• When replacing the O-ring or gasket, check the fitting condition at the mounting surface to prevent it from being
twisted and broken.
8.
Use the filter wrench to tighten the filter element about a three-quarter turn.
9.
Remove the oil filler cap and refill the specified engine oil from the oil filler port, referring to "LUBRICANT,
FUEL & COOLANT SPECIFICATIONS" in Chapter 4.
10. Use level gauge (4) to check the engine oil level. Refill the engine oil to the proper level, which is between
upper limit (H) and lower limit (L).
11. Attach oil filler cap (1).
Copyright©2020 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YY00041ZE03] [0701CsCshWbYs]
