1-25
ATTACHMENT MODE SELECT SWITCH
Check the attachment installed matches the selected attachment mode and is appropriate for the task to be
performed. If the attachment mode selected does not match the attachment, the machine will not work properly and
it will result in serious injury, death, or property damage.
See "SWITCHING ATTACHMENT MODE" in Chapter 3 for additional information.
CHECK CONTROL PATTERN BEFORE OPERATING
Before operation, always check the operation of each control lever and each pedal.
If the movement of the machine does not match selected control pattern which is shown on the card, stop the work
and shut down the machine. The machine movement must match with the operating pattern.
If the machine movement does not match the card displayed in the cab, change the card so as to match the
machine control pattern.
If any issue is found, do not operate machine until the issue had been corrected. If needed, contact your KOBELCO
authorized dealer.
CHECK WARNING DEVICES
Make sure that the horn, the travel alarm, the swing flashers and all other warning devices are warning properly.
AVOID INTERFERENCE BETWEEN THE ATTACHMENT AND THE MACHINE
Check clearance between the attachment and the cab
before starting operation because a certain kinds of
attachment and a certain combination of the option and
the machine may cause the contact of the attachment
and the cab or some other parts of the machine.
PRECAUTIONS OF SWINGING / TRAVELING
• Always sound the horn before starting the engine,
traveling the machine, or swinging the upper structure
to alert people in the vicinity of the machine.
• Always operate at a safe distance from other
machines or obstacles in the vicinity of the machine.
• Place a signal person at poor visibility area.
Copyright©2020 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YY00041ZE03] [0701CsCshWbYs]
