Dynamic Acera 03/05 Rev. 05
Page 3-20
Pressing the work mode selector switch
once changes to “A” or assist mode, lo-
cated on the left of the three indicator lamps.
The mechatro controller analyzes the operator’s
pattern of joystick lever movement, and uses
“fuzzy logic” to set one of five machine operat-
ing parameters FIGURE 3.15.a
b. A (Assist) mode SK160~SK330
Once the mechatro has analyzed the operators
joystick pattern, a moving graphic FIGURE
3.11.b (icon) flashes on the message display of
the monitor screen to show the operator which
assist mode is selected. Control is made easier
as the machine uses this pattern to “ASSIST” in
setting adequate pump and engine operation.
Operating efficiency increases FIGURE 3.15.c
without the operator even noticing.
Results
Control Mode
( Contents on multidisplay
Simple digging,
ditch digging, trench
box digging
Leveling,
slope finishing
Spreading
Tamping
Traveling,
waiting time
DIGGING
LEVELING
SPREADING
TAMPING
STANDBY
FIGURE 3.15.c
FIGURE 3.15.b
LEVELING
COMPACTING
SCATTERING
FIGURE 3.15.a
MACHINE FAMILIARIZATION
