Page 3-27
Dynamic Acera 03/05 Rev. 05
ED190Floating
D9. Removing the Travel Control Levers
a.
Use a 13 mm wrench to remove the travel
control levers from the travel pedals, See
Figure 21.d.
b.
Use a 17 mm wrench to remove the sup-
port brackets located in the air cleaner
compartment, See Figure 21.e.
c.
Store the travel control levers properly in
the air cleaner compartment and securely
tighten the brackets.
Two switches are located on the dozer con-
trol handle:
1.
Angle Blade
Control Switch:
It is located in
front of the dozer
control handle.
Depress this
switch on its left
corner to angle
the blade toward
the left, or de-
press it on its right
corner to angle
the blade toward the right. See Fig. 21.a
ED190AnglingBlade
RIGHT
ANGLE
LEFT
ANGLE
2. Dozer Blade Float Control Switch:
It
is located on the left side of the dozer con-
trol handle. Depress this switch to make
the blade float, See Fig. 21.b. Pull back
the dozer control lever to disengage the
float function.
FIGURE 21.a
DEPRESS THE
SWITCH TO ACTIVATE
THE DOZER FLOAT
FUNCTION
FIGURE 21.c
YQ102Travelpedals
FIGURE 21.d
FIGURE 21.e
MACHINE FAMILIARIZATION
