MINOR CHANGE MACHINE FAMILIARIZATION
2
Dynamic Acera 03/05 Rev. 05
Page 3-69
1515 RPM
1920Hr
HYD
AFT
CH
OIL
LCD DISPLAY
SERVICE FUNCTION ICON SEQUENCE
MONITOR ALARM
Normal
Display
Asist Mode
Display
Warning
B (Breaker)
Mode Display
1
MECHATRO
CONT. FAIL
CPU
2
SWINGBRAKE
DISENGAGED
4
E/G
PREHEAT
5
FINISH
PREHEAT
6
LOW E/G
OIL PRESS
7
HIGH E/G
COOL TEMP
9
REST’D AIR
CLEANER
8
REST’D E/G
OIL FILTER
10
ATTACHMENT
OVER LOAD
11
CHARGING
PROBLEM
21
WARMING UP
WARM
28
FINISH
WARM
19
POWER
BOOST ON
20
HEAVY LIFT
29
CHANGE
E/G OIL
ALARM NOT ACTIVE
ALARM NOT ACTIVE
¥For the description of display
of the work mode, refer to
Section 3.
Each display flickers during
this mode.
Within 5 sec.
(Automatically)
15
LOW E/G
OIL LEVEL
12
LOW
FUEL LEVEL
13
LOW HYD
OIL LEVEL
14
LOW E/G
COOL LEVEL
¥Alarm activates when icons
#2, #5, #6, #7, #10, #28, #32,
and # 33 display.
Supplementary Explanation:
¥ Icons #5 and #6 are displayed
and the monitor alarm does not
stop even if the buzzer stop
switch is pressed. When icon
#6 is displayed, the engine
RPM will idle immediately and
the engine will shut down after
5 seconds.
¥When icon #7 is displayed the
alarm activates and can be de-
activated by pressing the
buzzer stop switch.
¥Icons #2, #3, #10, and #28 are
displayed and alarm activates
intermittently and stop sounding
after 5 seconds.
Flow rate can be adjusted.
Double pump flow can be
selected.
Travel control pedals must be
in neutral before activating function
Use to ensure the time of the
replacement for the inspection,
service, etc.
When pressing the screen
change switch, make sure to
hold switch down for 0.5 sec.
to properly change the screen
display.
Machine normally starts in
M mode, except the long reach
option machine. Long reach
machine starts in A mode.
Spreading mode
Tamping mode
Clock icon
Machine status display
Time display
Time display
Tachometer display
Digging mode
Leveling mode
14 : 20
14 : 20
256Hr
E/G
AFT
CH
OIL
256Hr
FUEL
AFT
CH
FIL
256Hr
HYD
AFT
CH
FIL
FLOW
RATE
L
min
MONITOR
SYSTEM
OK
YQ102MonitorDisplayIcons
TRAVEL
INDEP. MODE
B
Independent
Travel Mode
Display
ALARM NOT ACTIVE
B
32
DRAINING
HYD. PRESS
PR
33
FAIL DRAIN
HYD. PRESS
PR
The following chart is provided to familiarize personnel
with the priority of the Monitor Display Icons. Pay close
attention to these icons as they can help in avoiding un-
necessary repairs and expense.
The icons in the chart below are listed in priority from the
most serious to least serious.
EXAMPLE: If the engine oil pressure is abnormal and Fuel
level is low, the engine oil pressure Icon will display and
buzzer will sound. After the oil pressure is back to safe
operating pressure, the low fuel Icon will display.
