MINOR CHANGE MACHINE FAMILIARIZATION
2
Dynamic Acera 03/05 Rev. 05
Page 3-79
C2. 12 Volt Power Supply – FIGURE 2.25A
The 12 volt power supply is located beside the right
side switch panel.
For use of common auto accessories such as a
fan or other accessories requiring 12 volt(DC)
power, pull cover away from 12 volt power supply
and insert 12 volt male socket into power supply.
Replace cover after use.
C3. Fuse Box – FIGURE 2.25B
The fuse box is located behind the operators seat.
It contains all necessary fuses for the electrical cir-
cuits of the machine. Should it become necessary
to inspect or change a fuse, remove the fuse box
cover by gently pulling each end away from the
box. Should a fuse require replacement, use a re-
placement fuse of the same type and amperage.
Turn key switch to “OFF” and wait approximately 4
seconds for all electrical power to stop before re-
moving or replacing a bad or blown fuse. The fuse
cover incorporates a fuse puller to remove fuses.
Refer to the Maintenance Section of this manual
for a detailed diagram and description of fuse box.
C4. Hour Meter – FIGURE 2.25C
– The hour meter indicates the total time that
the engine has run. It meters the time con-
tinuously as long as the engine is running.
Do not use the cigarette lighter as a power source for 12
volt accessories. It is a 24 volt outlet. Plugging a 12 volt
accessory into a 24 volt connector may result in short-
ing and/or Fire.
MAXIMUM CONTINUOUS OUTPUT – 180 Watt
CAUTION
FA
N
T
E
M
P
D
E
F
M
O
D
E
R
/F
YQ102 12Vadapter
HOUR METER
12 VOLT ADAPTER
FIGURE 2.25A
FIGURE 2.25B
FIGURE 2.25C
FUSE BOX
FUSE COVER
