1.
Before checking, find level place, stop
machine locating plug (1) bottom, and move
safety lock lever to "LOCKED" position.
2.
Remove level plug (2) and check for short
of oil level and contamination. If the oil
level is to the top side of level plug, it is in
proper level. If shorted, remove fill plug (3)
and make up short of specified gear oil.
For specified gear oil, refer to the section
"LUBRICANT, FUEL & COOLANT
SPECIFICATIONS".
3.
Clean level plug (2) and fill plug (3) with
light oil, and then attach it in place.
4.
Similarly check on the travel reduction unit
on the other side.
B.
Travel Reduction Unit Oil
-Travel reduction unit could be under pressure. Carefully loosen plug and remove slowly filled air
pressure. Where the plug was loosened abruptly, there is the danger of spouting out of plug and oil.
Do not face the plug to prevent from flying plug etc.
-Never change oils on a machine that has just finished working. Allow machine to cool first until oils
and fluids are warm not hot.
[
4. MAINTENANCE
]
4-42
Copyright © 2015 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YF00022ZE01] [0731CsCshWbYs]