6.
Remove dust, mud, etc. from seal surface of oil
filter.
7.
Fill new filter with engine oil, apply engine oil to
gasket and fit it in place turning the filter by
hand to the position where it is in contact with
the filter seal surface.
8.
Tighten it 3/4 to 1 turn with filter wrench.
9.
Fill it with specified engine oil through oil filler
cap (1) referring to the section "4.3
LUBRICANT, FUEL & COOLANT
SPECIFICATIONS" in Chapter 4.
10.
Attach oil filler cap (1).
11.
Check that the reading of oil level gauge (4)
is between upper limit and lower limit, crank
engine and start the engine. Stop engine after
idling for several minutes and check the oil
level after about 10 minutes, and if the level is
low, fill oil pan with the specified engine oil.
12.
Check oil filter attaching face for oil leak.
13.
Attach cover in place under engine and close
engine hood.
1.
When replacing the fuel filter, clean the area
of filter up.
2.
Prepare container for drain oil.
3.
Close fuel cut valve (A) placed on the halfway
of fuel filter line.
４
B.
Replacing Fuel Filter
The fuel filter is placed on the area where the inside of door on the machine right rear.
［
4. MAINTENANCE
］
4-55
Copyright © 2015 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YF00022ZE01] [0731CsCshWbYs]
