1.
Check the engine mounting bracket (1)
and the rubber mount (2) for damage,
deterioration and for looseness of bolt (3)
and nut (4).
2.
If damage or deterioration is found on
mount bracket (1) or rubber mount (2),
please contact our dealer/distributor for
replacing.
3.
Regarding tightening torque of bolt (3) and
nut (4), refer to Section "4.6 TORQUE
VALUES FOR SPECIFIED".
４
C.
Checking Engine Mounting Bracket for tightening
D.
Checking Voltage
-Wear hard hat, approved safety glasses or face shield, gloves and other safety equipment when
working with batteries.
-Flammable gas (hydrogen gas) is generated in the battery. Do not allow sparks or flames to come in
contact with batteries to avoid triggering an explosion.
-Battery fluid has strong acid. It corrodes metal very rapidly. If it adheres on skin or enters into eye,
it causes for a burn or blindness.
At such case, immediately wash skin or eye with lots of water, and ask a doctor to treat it as soon
as possible.
-Stop the engine and carry out maintenance and checking service for the battery.
-Remove battery terminal from grounding side (negative terminal) first, and conversely fit the terminal to
the grounding side last.
-Do not put tools and hardware on protective cover installed on the battery upper section.
There is a hazard of explosion because the short-circuit may catch fire.
1.
Measure the voltage of battery and if the measured value does not reach the specified voltage,
recharge or replace battery.
-Clean battery terminal and apply grease or commercial lube oil rust preventive spray.
-Call in licensed specialty company for the disposal of used battery.
-Be careful not to use the old battery together with new battery. It may reduce the service life of
battery. Therefore replace two batteries together with new ones if required to replace.
［
4. MAINTENANCE
］
4-67
Copyright © 2015 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YF00022ZE01] [0731CsCshWbYs]
