Located on hydraulic pump cover.
Part Number - YN20T01220P1
Engine may be hot which could cause burns.
Do not touch engine until it cools down.
・
This work must be done carefully by two
people. The operator must operate the
machine as instructed by the signals of
the partner.
The crawler belt is changed by lifting one
side of the machine at a time. Unexpected
lowering or movement of the machine can
result in serious injury or death.
Do not operate the boom, arm or bucket /
attachment while removing or installing a
crawler belt.
Follow the instructions provided.
・
Grease in track tensioning mechanism is
under extreme pressure and can penetrate
skin causing severe injury. Keep face and
body away from grease fitting area. Do
not loosen grease fitting more than one
turn. If grease does not release after one
turn of the fitting, call our dealer/distributor
for assistance.
・
Before removing the rubber crawler belt,
confirm that the pressure inside the track
tensioning cylinder has been completely
released. Then turn the sprocket.
・
If the procedure on releasing the pressure
in the track tensioning cylinder is not
followed, grease can penetrate skin
causing severe injury. If the tension of
rubber crawler belt does not release, call
the dealer/distributor for repair service.
1
11. HOT PARTS
12. ADJUSTING TRACK TENSION
Located on crawler frame.
Part Number - YN20T01813P1 (2REQ'D)
[
1. SAFETY PRECAUTIONS
]
1-11
Copyright © 2015 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YF00022ZE01] [0731CsCshWbYs]