Before starting the machine, check the position
of front idler (1). In the proper travel position,
the front idler (1) is positioned on the front side
and travel motor (2) is on the rear side.
Check clearance between bucket and cab
before operation. Slowly cycle bucket, check
for interference with arm and cab, particularly if
a lifting eye is welded on bucket bottom.
Exercise care when operating the bucket near
the cab.
・
When running, keep the attachment in the
position the height from the ground is 30 to
40 cm (1 to 1.3 ft) as shown in the figure.
・
The abrupt control lever operation and
pedal operation are not allowed.
・
When traveling on rough terrain, travel at
slow speed.
・
Travel the machine while keeping away
from the obstruction as much as possible.
If it is unavoidably necessary to get over
the obstruction, travel at slow speed while
keeping the position of attachment close to
the ground.
H.
CONFIRM OPERATING CONTROL PATTERN
Slowly operate the control levers to confirm the operating patterns in advance. Make sure the operation
control pattern is according to the indication plate.
I.
CONFIRM TRAVEL DIRECTION
J.
PROHIBIT RAPID LEVER OPERATION IN TRAVEL
・
The rapid travel operation like urgent start is prohibited.
・
The rapid lever change from forward to reverse (from reverse to forward) is not allowed.
・
The rapid lever operation like urgent stop from the speed close to the maximum is not allowed.
K.
DO NOT HIT CAB WITH ATTACHMENT
L.
PRECAUTION TO BE TAKEN IN TRAVEL
The firm and level ground must be used for traveling. And select the road in straight and large radius
curve as much as possible, do not take sharp pivot turn and spin turn. In narrow area, swing the
wheel in the opposite direction as many times as possible.
［
1. SAFETY PRECAUTIONS
］
1-26
Copyright © 2015 Kobelco Construction Machinery Co.,Ltd. All rights reserved. [S2YF00022ZE01] [0731CsCshWbYs]
