Kobots AMIGO 912, Manual

ENGLISH

8. Store Amigo® securely 

When Amigo® is not being used it must be stored in a dry, high location, in a locked area outside the reach of children. 

9. Use Amigo® properly 

Amigo® must not perform any work for which it is not designed. Do not use Amigo® for purposes for which it is not desig-
ned, such as cutting materials that are not specified in these instructions. 

10. Dress appropriately 

Do not wear loose clothing or jewellery. They may get caught in moving parts. Long hair may constitute a hazard if it comes 
into contact with moving parts. Tie your hair back so that it is does not pose a risk

. 

11. The cord must not be mishandled 

Never use the cord to support Amigo’s parts and do not pull the cord to remove it from the socket. Do not expose the cord 
to heat, oil, pressure or sharp edges. 

12. Check the spoilboard 

The spoilboard is the board that is incorporated into Amigo® as a cutting surface. Check the state, location and the thick-
ness of the spoilboard. The spoilboard must be stable and must cover the entire cutting area. If necessary, cut one or more 
additional boards if a spoilboard of the cutting area’s size cannot be obtained with a single complete board. 

13. Ensure that the workpiece is positioned in a stable manner 

Always check that the workpiece is positioned correctly and is stable without tilting. 

14. Disconnecting the connector from Amigo® 

The electricity supply must ALWAYS be disconnected or switched off before the connector is disconnected from Amigo®. 
This also applies to motor plug, the connector for the angle grinder or vacuum cleaner. Dangerous situations may arise (for 
example, the cutting head may move) if the connector is disconnected while the electricity supply is connected.

15. Remove the connector from the power socket 

Remove the plug from the power socket when Amigo® is not in use, before and during servicing and when replacing acces-
sories. 

16. Avoid unintended start-ups, do not move Amigo® around while it is assembled 

Do not move, push or lift Amigo® while it is assembled. 

17. Danger of clamping 

Keep body parts away from Amigo® when it is moving. 

  
18. Be alert 

Do not use Amigo® when you are tired, have consumed alcohol or an under the influence of any other types of intoxicating 
agents whatsoever. 

19. Check Amigo® for any damage before you connect the cable to the power socket 

a. Before using Amigo®, check that the moving parts are functioning perfectly and are not jamming and that none of the 
parts are broken. 
b. Check that all the parts have been mounted properly and secured and that other conditions that may impact on Amigo’s 
operation are in order. 
c. If safety devices or other parts are found to be damaged, Amigo® must not be connected to the power supply. 
d. Parts that are found to be damaged must be repaired or replaced by an authorised service workshop unless instructed 
otherwise in the user instructions. 

20. Have your tool repaired by an authorised KOBOTS service workshop 

Amigo® complies with the relevant safety rules. To avoid any danger, repairs on Amigo® must only be carried out by an 
authorised workshop. 

Intended use 

Do not use Amigo® for any purpose other than to format-cut panel material in plasterboard and fibre plasterboard. Do not 

saw metals, masonry or any other material.

 8   Model 912        Rev. 4