Product and Safety Specifications
132
www.kodak.com/go/aiosupport
Safety information
KODAK HERO 9.1 All-in-One Printer is a Class 1 LED Product.
• Always follow all warnings and instructions marked on the product.
• Use only a Hipro HP-A0601R3 or Flextronics VP-09500084-000 certified
external power supply (provided with the product).
• Use only the power cord that comes with the product (or an approved power
cord greater than or equal to H05W-F, 2G, 0.75 mm
2
). Using another power
cord may cause fire and/or shock. Do not use the included power cord with any
other equipment.
• If you do not use this product for a long period of time, unplug it from the
electrical outlet.
• Always turn this product off by using the On/Off button. Wait until the On/Off
button stops flashing before removing the power plug from the outlet.
• Do not allow the power cord to become damaged or frayed.
• If you need to use an extension cord with this product, make sure that the
ampere rating of the product does not exceed the ampere rating of the extension
cord.
• Place the product on a flat, stable surface that extends beyond the product’s
base in all directions. This product will not operate properly if tilted or at an
angle.
• When storing or transporting this product, do not tilt or stand it on its side.
Never turn this product upside down (ink can leak out of the product).
• Avoid placing this product in an environment that is subject to rapid changes in
temperature or humidity, mechanical shocks, vibration, or dust. Do not place
near radiators, heating vents, or in direct sunlight.
• Leave enough room around this product for sufficient ventilation.
• Do not block this product’s covers or openings, or insert any objects through
slots.
• Do not use aerosol products inside or around this product.
• Do not spill any liquid on this product.
• Do not attempt to repair or service this product.
• If the power cord or plug is damaged, if any liquid has been spilled onto the
product, if the product has been dropped or the case damaged, if the product
does not operate normally or exhibits a major change in performance level,
unplug this product and contact Kodak at
www.kodak.com/go/contact
.
For Service Personnel:
CAUTION:
Risk of explosion if battery is replaced by an incorrect type. Dispose of used
batteries according to local instructions.