Kodak i3000 Series, Scanning Setup Manual

30

A-61789/ISIS  January  2016 

-

Medium

: use Medium sensitivity if your application has varying 

document thickness or labels attached to the document. 
Depending on the label material, most documents with labels 
should not be detected as a multifed document. 

-

High

: the most aggressive setting. This is a good setting to use if 

all documents are similar in thickness to 75.2 g/m

2

 (20-lb.) Bond 

paper.

•

Action

 — select what action you want the scanner to take when a 

multifeed is detected. With all options, the condition will be logged in 
the scanner.

-

Continue Scanning

: the scanner will continue to scan.

-

Stop Scanning

: scanning will stop and control will return to the 

scanning application (i.e., ends the job). Verify that the paper path 
has been cleared and restart the scan session from the scanning 
application.

-

Stop Scanning - generate image(s)

: scanning will stop and 

control will return to the scanning application (i.e. ends the job). 
Image(s) of the multifed document will be generated. Verify that 
the paper path has been cleared and restart the scan session 
from the scanning application.

-

Pause Scanning

: scanning will stop but the scanning application 

will be waiting for additional images (i.e., stops the feeder). 
Scanning may be resumed by pressing the 

Start/Resume

 button 

on the scanner. Scanning may be stopped by pressing the 

Stop/

Pause

 button on the scanner or via the scanning application.

-

Pause Scanning - leave paper in path

: scanning will stop 

immediately (i.e., making no attempt to clear the paper path) but 
the scanning application will be waiting for additional images (i.e., 
stops the feeder). Clear any documents from the paper path prior 
to resuming the scan session. Scanning may be resumed by 
pressing the 

Start/Resume

 button on the scanner. Scanning may 

be stopped by pressing the 

Stop/Pause

 button on the scanner or 

via the scanning application.

-

Stop Scanning - leave paper in path

: scanning will stop 

immediately (i.e., making no attempt to clear the paper path) and 
control will return to the scanning application (i.e., ends the job). 
Clear any documents from the paper path prior to restarting the 
scan session from the scanning application.

Speaker icon

 — clicking this icon will display the Open dialog box 

allowing you to select the desired tone (.wav file) for your alarm. 

Calibrate

 — displays the Calibration window allowing you to perform a 

UDDS

 calibration.

NOTE: Frequent calibration is not necessary or recommended. Only 

perform a calibration when instructed to do so by your support 
personnel.