Operating Procedures
3-30
September 2000
Setting the Page Starts Value
1.
Select “Setup” from the main menu on the OCP.
2. Select
“Printer”.
3. Select
“Page Starts”.
4. Select the Page Start you want to modify.
5. Use
the
Up and Down Arrows to select a new Page Start value.
6. Press
Select to select the new value.
7. Select
“Exit” to return to the previous menu on the OCP.
Producing Borderless Prints
To achieve borderless prints on both the front and back edges of the paper, you
must set the Page Starts value to adjust the location of the image so that both
edges of the image will print off of the paper.
NOTE: The image width must be at least 76 pixels wider than the width of the paper
to ensure a borderless print. For example:
If white borders are present on either the front or back edge of the print:
1.
Measure the white border at both the lead (distance A) and the trail edge
(distance B) and determine its average width.
2. Convert the average width of the white border to a pixel value.
Paper Size
Image Width in Pixels
10 inch
2576
11 inch
2826
12 inch
3076
20 inch
5076
A4
3000
outline of the paper
outline of the image
back edge
page start
front edge
Summary of Contents for LED II PRINTER 20R - OPERATOR'S GUIDE
