14
www.kodak.com/go/support
Appendix
■
Go to
www.kodak.com/go/reach
for information about the presence of substances
included on the candidate list according to article 59(1) of Regulation (EC) No.
1907/2006 (REACH).
■
If using this product in an airplane, observe all instructions of the airline.
■
For more information, go to
www.kodak.com/go/batteries
.
Care and maintenance
■
Before inserting or removing a card, make sure your hands, the camera, and the
card are completely dry.
■
If water has entered the camera, remove the card. Allow all components to air-dry
for at least 24 hours before using the camera.
■
Wipe off dirt or sand from the door seals—debris could compromise the seal and
cause a leak in water.
■
Do not subject the camera to temperatures lower than 0 (32
°
F) or higher than
40
°
C (104
°
F) for an extended time—the integrity of the seals may be
compromised. Wait until camera reaches operating temperatures before using.
■
Blow gently on the lens or LCD to remove dust and dirt. Wipe gently with a soft,
lint-free cloth or an untreated lens-cleaning tissue. Do not use cleaning solutions
unless designed specifically for camera lenses. Do not allow chemicals, such as
suntan lotion, to contact painted surfaces.
■
Service agreements may be available in your country. Contact a dealer of KODAK
Products for more information.
■
For camera disposal or recycling information, contact your local authorities. In the
US, go to the Electronics Industry Alliance Web site at
www.eiae.org
or Kodak at
www.kodak.com/go/support
.
