Calibration
Back
Index
Contents
Next
86
To make temporary color adjustments:
1.
From the
Calibration
menu select
Send LUT to
Printer
.
2.
Select a Media name from the drop-down list,
then click
Next
. (If there is only one media type
in the calibration database, omit this step.)
3.
Select an event number and date, then click
Next
.
4.
Select
Apply Master Balance
to apply a
temporary adjustment to the colors for this print
job.
5.
Adjust the temporary values for the Red, Blue,
Green, and Density and click
Next
.
6.
Ensure that all printing has stopped, then click
Finish
in the Send LUT to Printer dialog box.
NOTE: When sending a temporary color
adjustment, the final dialog box is a different
color than the other dialog boxes in the wizard.
Performing a Complete Calibration Analysis
Performing a complete calibration cycle includes
printing and analyzing a calibration target.
If you perform a complete calibration cycle, you
cannot print anything else until the cycle is
complete.
1.
From the
Calibration
menu select
Perform
Complete Calibration Cycle
.
2.
Select the media to calibrate, then click
Next
.
3.
Select a starting point (see
page 78
).
NOTE:
If you select Designated Calibration Event
as a staring point, you must select an event
number and date from the drop-down list.
4.
Click
Next
to print the calibration target.
5.
Analyze the target (see
page 80
).
