English
48
Device Status
You can check the status of the unit, such as remaining ink level.
Device Configuration
•
General Settings
You can change the following items.
• Default paper size/type
If you change this setting, the default paper size/type in Copy
Menu setting are also changed.
• Sleep mode time
You can change the time required before unit enters sleep mode
from [1 min/10 min/20 min/30 min/40 min/50 min/60 min/70
min/80 min/90 min/100 min/110 min/120 min].
•
Print Reports
You can print out the configuration report.
•
Factory Reset
You can restore the default settings to the unit.
Note(s)
❏
• The unit will automatically restart after reset to factory settings.
(The Web Interface will be disconnected.)
Network
If necessary, you can confirm or set the state of the network. If you
are not familiar with network management, use the default settings.
Note(s)
❏
• Be careful if you want to assign the IP address manually. If the
IP address you entered is not correct, you will not be able to
connect to the unit. When you cannot connect to the unit after a
configuration change, please reset the unit.
»
Refer to “Restore Factory Default” on page 46.
• When the connection of the unit is changed, the Web interface
will be disconnected. If necessary, reconnect the Web interface.
•
Enable Wi-Fi
You can turn On / Off the Wireless function.
Note(s)
❏
• Even if the Wireless function is set to Off, when you connect by
Easy Simple Print, the Wireless function will be valid.
• When you have connected the unit to the access point/router, if
you set to disable Wi-Fi, you will not be able to operate from the
Web Interface. If you connect to Wi-Fi again, select the “Enable”
from the “Enable Wi-Fi” of unit menu.
»
Refer to “Enable Wi-Fi” on page 43.
•
TCP/IP (IPv4) Settings
You can change the IP source / IP address or the like.
Note(s)
❏
• The initial value of the IP Source of Wireless is DHCP.
•
IPv6 Settings
This unit supports IPv6 in order to support AirPrint.
You can check the information on IPv6.
Continued on next page.