3-6
DP5000 Series Printers
Chapter 3. Printer Installation
Fluid Container Installation
Replenisher Bottle
Use the following procedure to install the replenisher bottle:
1. Locate the fluid bottle connections inside the ink compartment (see
Figure 3.4).
2. Carefully open the cardboard container and remove the cap from the
bottle.
Note: Retain the cap to put back on the empty bottle when it is removed.
3. Install the replenisher container in left position between the metal
supports with the cutouts in the container facing out (toward the door).
Hint: Pull up on the bottle neck while sliding it into position.
4. Make sure that the flower-shaped collar of the bottle is above the
metal support arm.
Caution:
If the bottle collar is left under the support arm, the bottle (bladder) will
collapse inside the container and block the bottom of the replenisher
supply tube. Over time, this problem produces high ink concentration.
5. When you position the container, listen for the click of the quick-
disconnect. The click confirms that the ink supply connection has
sealed properly.
6. Press down on the locking plate until it punctures the bottle seal and
locks the container into place.
7. Continue with the “Voltage Selection” or “Printer Connections”
procedure.
Summary of Contents for VERSAMARK DP5120
