24
DS5600 Series Printing Systems
Chapter 2. Operation
Controller Operation
Device Configuration
To print, each printer must be configured in the CS150 software. Use the
following procedure to assign each printer to a service and configure that
printer for use by the system:
1.
In the
Dashboard
window, select
Diagnostics
. The
Diagnostics
window appears.
2.
Select
Services
New Service
(or press C
TRL
+ I
NSERT
) to create a
service view for each printer or print station connected to the
controller. An Unknown device icon appears (see example at left) and
the
Select Service
dialog appears (Figure 2.6).
Figure 2.6
Select service setup window, CS150 software
3.
Select
Kodak Service
and click
OK
. The
Service Dialog
appears.
4.
Select the correct
IP address
for the device from the drop-down
menu and then click
OK
.
Note:
The address selected must be set using DIP switches on the Compact DS
Main Board in the printer or print station, and two devices cannot have the
same address. If the address does not match the hardware setting, the
warning “this device is not connected” appears when the device icon is
selected. Contact your supervisor or a service technician if a device
address needs to be changed. When the new device connects, select it
by double-clicking the
New Device
icon in the list under
Services
. A
dialog appears asking you to name the new device.
Unknown
Summary of Contents for Versamark DP5630
