34
DS5600 Series Printing Systems
Chapter 2. Operation
Print Station Operation
During operation, the following status displays should be monitored:
Eyelid Status
Shows data station or print station eyelid control.
Remote Eyelid
is
data station control and
Local
is print station control.
Function Status
Displays the function name. When the display flashes, the function is
active; otherwise the function is not running or has been completed.
Time Remaining
Displays a countdown (in seconds) until the function is complete.
State Number
Displays which state is active. All states are numbered. The number
changes to indicate the state.
Table 2.1 lists all status information displayed on the various screens.
Table 2.1
System status display summary
Parameter/Component
Possible Statuses
Range in Ready
Description
Fluid servo
On
14.00 to 16.00 psi
Pressure values below 14 psi occur during
bringup or shutdown.
Vacuum servo
On
On hold
9.9 to 14.0 in. Hg
Values above 14 in. Hg occur during clean
or shutdown.
Printhead
(speed)
Link down
Link error
Printhead serial
number
Indicates whether the print station can
communicate with the printhead.
Stim drive
On
Unlocked
0.200 to 0.700 V
RMS
Unlocked indicates a printhead
malfunction. Values above 0.4 are normal
during clean or bringup. Will go as high as
1.5 V
RMS
during a sonic cleaning cycle.
Charge plate heater
On
-
Status of the heater that prevents ink
condensation.
Printhead ink/
ambient temperature
-
15 to 45 C
Ink's temperature and the air temperature
in the printhead.
Charge voltage
On
Low
50.0 to 150.0
VDC
Voltage on the charge plate.
Ink concentration
OK
Low
High
Not applicable
Darkness of the ink. Replenisher is added
as necessary. A constant low or high state
may indicate a problem.
Ink level
OK
Low
Empty
Filling
High
Not applicable
Amount of ink in the ink tank. Ink is added
as necessary. A constant empty, filling, or
high state may indicate a problem.
1
Printhead use
-
0 to 65000 h
Accumulated hours the printhead has
operated.
Print station use
-
0 to 65000 h
Accumulated hours the print station has
operated.
2
1.
OK displayed as light blue text = ink drawn from the external ink supply at the next fill. OK in dark blue = ink drawn from the external
replenisher supply at the next fill.
2.
If INSTALL is used when updating software, the accumulated hours will be reset to 0 (zero). Use UPDATE to preserve the hour
record.
Summary of Contents for Versamark DP5630
