38
DS5600 Series Printing Systems
Chapter 2. Operation
Print Station Operation
Parameters Menu Procedures
Use the selections on the
Parameters Menu
(Figure 2.20) to configure
the DT3 print station and printhead.
Figure 2.20
Parameters Menu, DT3 print station software
These settings are critical to proper operation of the equipment and
should be done at installation. Changes should be made only by a service
technician. This menu is password protected.
Note:Press
F10
to display information about the hours of operation for the
print station and printhead, the versions of software installed, and the type
of ink in use.
If necessary, make changes to the following parameters after consulting a
service technician or technical support:
•
Pressure adjustment
•
Vacuum Adjustment
•
Stim adjustment
•
Stim phase adjustment
•
Charge voltage adjustment
7 Sequence
summary
Allows you to review the current values, times, and states for print station valves,
motors, and sensors. Selecting this item displays the
Sequence Summary
screen.
The following sequences can be selected:
•
Ready
•
Shutdown PH
•
Standby
•
Short Recover
•
Install Clean
•
Vacuum/Ink Fill
•
Long Clean
•
Service Clean
•
Fast Ready
•
Step to Ready
•
Fast Recover
•
Clean
•
Ink Too High
•
Shutdown PH
•
Carryover
8 Control menu
Used to exit to the
Control Menu
.
9 Parameters menu
Used by supervisors, field engineers or maintenance technicians to perform more
detailed maintenance. The
Parameter Menu
screen is password protected.
Table 2.3
Service menu function (Continued)
Item
Description
** PARAMETERS MENU **
Function Selections
1
Pressure
2
Vacuum
3
Stim. / Stimgram
4
Stim. phase
5
Charge voltage
6
---------
7
Standby
8
Service menu
9
Setup menu
Choose a function, enter the number
Press F1/F2 key for HELP
.
Summary of Contents for Versamark DP5630
