Operator Guide
47
Chapter 4.
Operator Maintenance
This chapter describes routine maintenance procedures that must be
done to ensure that the system continues to operate properly. These
tasks take only a few minutes and do not require any tools.
Daily Maintenance
For
Kodak Versamark
DH5222 Printheads and
Kodak Versamark
DH5340
Printheads, the following tasks should be done as needed or every 8
hours of run time, whichever is more frequent.
Printhead Bottom Cover Cleaning
Clean the cover that protects print array on the bottom of the printhead
enclosure by removing the cover and rinsing it off with ordinary tap water
or D.I. water. To remove dried ink, soak the cover in warm water, then
wipe it off. For an illustration of the specific type of cover and its location,
see the document shipped with the printhead.
Printhead Cleaning
Wipe ink, dirt, and paper dust off the exterior of the printhead with a soft,
damp cloth. Mild detergent can be used if needed. Do not spray water or
any cleaning fluid direct on the printhead. Apply water or detergent to the
cloth used to wipe the printhead. Clean the printhead covers under the
following circumstances:
•
Before printing, as needed, with POC bypassed or in standby
•
When the printhead bottom cover is cleaned
•
When visible ink or paper dust accumulates on any part of the covers
•
When the printhead is swabbed, or after any other service procedure
Summary of Contents for Versamark DP5630
