1 - 6
Chapter 1. Getting Started
Supporting the Printhead
Supporting the Printhead
The printhead support must hold the printhead steady to protect it from
vibration. The support must hold the printhead within 0.250 to 0.375 inch
of the substrate (6-10 mm), and support the weight of the printhead and
umbilical. Optimum print quality is obtained by keeping the printhead as
close as possible to the substrate.
Refer to the installation instructions shipped with the printhead mount for
assembly and installation instructions. The printhead mount holds the
printhead over a label base or document transport (Figure 1.4).
Figure 1.4
Printhead mount
Summary of Contents for VERSAMARK DP7122
