Chapter 5 Installation
CVS-1410B
5-6
0093114105-03
5.3 Installation
of
Transducer
The standard installation of the transducer is shown in figure 5.6.
Figure 5.6 Installation of Transducer
In case of Inner-hull
Using the optional inner-hull kit, install the transducer to the inner side of ship’s bottom.
Caution on installation
(1) Select the location where no bubble is generated during navigation.
(2) Select the relatively thin location of ship’s bottom. (About 6mm)
(3) Be sure to remove oil on the contact surface. File the contact surface with sand paper (#400) so
that the adhesive strength will increase.
(4) The adhered surface will dry in about two hours.
(5) Leave the unit for a whole day and fill in the coolant. More than 80 % of the transducer should be
submerged in the coolant.
Caution: It is strongly recommended to confirm the location of the installation of Inner-hull
with the ship manufacturer. The Inner-hull device is more simplified method. The gain
falls dramatically in comparison with the Through-hull performance. Low frequency (50
kHz) may not be used due to large signal attenuation in some cases. Depth range
performance using 200 kHz Transducer in case of Inner-hull can be less about 50% than
that of Through-hull.
Caution: Fishing boats may have structure with FRP contained air bubbles and foamed
materials that would prevent ultrasound from penetration. Therefore, the location
convenient for installation may not be locations where attenuation of ultrasound is low
enough.
Inner-hull kit
Figure 5.7 Inner-Hull installation
The upper part
Packing
Main body
Inner-Hull kit MFB-04W
B
O
W
/
S
TERN
(5 45/64)
(4 31/64)
(7 1
/4
)
(8 15
/32
)
Unit: mm (inch)
