KGP-920
Chapter 4
Installation
0093121662-08
4-1
Chapter 4 Installation
4.1 Installation consideration
General
Qualified service technicians should perform the installation of the KGP-920 series that comprises the
following operations.
(1) Unpacking each component of the system.
(2) Inspection of the exterior of each component unit and accessory.
(3) Checking the ship’s mains voltage and current capacity.
(4) Determining the installation site
(5) Installing the Display unit
(6) Planning the cable routing and connections
(7) Adjustment and setups
4.2 Unpacking of the goods
Unpack your package and check if all of the items stated in the packing list are contained in the
package. If not, report this to an insurance agent for tracing missing goods or refund.
4.3 Inspection of the goods
Carefully check the exterior of each component unit for dents, damage, etc. Also check the inside of
component units for electrical and mechanical damages.
4.4 Siting the units
To achieve best operational performance, the following factors must be considered.
(1) The display unit should be positioned in the location where the external situation can be viewed.
(2) Locate the display so that it provides easy viewing from all likely operator’s positions.
(3) Select a position safe and free from dampness, water spray, rain and direct sunlight.
(4) Provide enough space for servicing. Consider access to the rear panel for connecting cables.
(5) Position the display unit as possible away from other radio equipment.
4.5 Display unit installation
The display unit is designed for table mount and flush mount. Refer to Figure 4.1or 4.3 for installation.
4.5.1 Table mounting
(1) Remove the two knurled fixing knobs that fix the display unit to the mounting bracket.
(2) Remove the display unit from the bracket and place it on a flat and safe area.
(3) Place the mounting bracket to the place where the display unit is to be installed, and fix the bracket
with two (2) tapping screws.
(4) Reset the display unit on to the bracket and fix it using the two knurled fixing knobs that were
removed in step (1). Refer to Figure 4.2 for detail.