KGP-925
Chapter 12 Communication with external navigation system
0093192502-00
12-3
12.2.2 Selecting route navigation
Procedure to navigate by the received Complete route by following steps.
(1) Press [
MODE
] key until
A
(NAV1),
B
(NAV2),
C
(NAV3) or
D
(PLOT) screen appears.
(2) Press [
SEL
] key until page 5 screen appears.
(3) Press [ ] or [ ] key to move cursor to “
ROUTE
” letters.
(4) Press [
ENT
] key.
(5) Press [ ] or [ ] key to select the required Complete route identifier (name or number).
(6) Press [ ] key
(7) Press [ ] or [ ] key to select the start waypoint identifier (name or number).
(8) Press [
ENT
] key.
12.2.3 Working (active) route transfer
When KGP-925 receives Working route data for the first time, it shows “LOADED ext. active route” and
goes into Working route mode regardless of previous navigation mode due to the first priority.
As far as KGP-925 receives Working route data within 10 seconds consecutively, it continues to work
for the received working route.
When waypoint is changed by reaching to the next waypoint or other reasons, “LOADED waypoint
change” is indicated.
If interruption of Working route data transfer exceeds 10 seconds, KGP-925 judges working route
navigation has ended and quits working in route navigation by indicating “DEACTIVATED ext. active
route” and goes back to the previous mode.
When an external route is received during working route navigation, it is rejected by showing
“REJECTED ext. route Route is active”.
The working (active) route is stored as number 20
th
route.
Cursor
Route identifier
Position data of the first
waypoint
The first waypoint identifier
Route identifier
The first waypoint identifier
LOADED
ext. active route
LOADED
waypoint change
DEACTIVATED
ext. active route
New Working route became valid
Waypoint was changed
Working route is finished
Summary of Contents for KGP-925
Page 1: ......
Page 37: ...Chapter 5 Basic Operation KGP 925 5 6 0093192502 00 Page 4 Close up of PLOT screen ...
Page 143: ......
