18
English
Installation
Fig.
1
Place the unit on a level and stable
surface. Keep the minimum distances to
all sides.
Fig.
2
Unevenness can be compensated with
the adjustable front feet.
Fig.
3
The refrigerator is equipped with four
glass shelves, which, if desired, can be
removed by pulling them forward. The
upper three glass shelves can be used
at different heights.
Warning
If the refrigerator has been stored,
transported or tipped sideways during
transport or installation, it must be in an
upright position for 12 hours before being
connected to the mains.
Operation
Fig.
4
Plug in the power plug into an
appropriate mains socket outlet.
Note:
Allow the product to precool for about 2-3
hours before storing food in it.
Setting the refrigerator temperature
Fig.
5
Turn the temperature dial to adjust the
temperature of the refrigerator. Check
the set temperature with a refrigerator
thermometer.
Adjust the sides of the doors
Note:
• If necessary, and if the premises require
it, the mounting of the doors can be
changed. To do this, follow all the following
instructions in the given order.
• The following tools are required:
hex-wrench 13 mm, wrench 8 mm, phillips
screwdriver. Due to the uniqueness of the
appropriate tools, those are not mentioned
separately in the following instructions.
• For this work a different cover is needed,
which is provided with the unit.
• For safety, remove the door trays to
prevent them from being damaged.
Top door
1
Loosen and remove the plastic caps left and
right. Unscrew the upper hinge plate. When
unscrewing, be sure to hold the refrigerator
door firmly, otherwise it will be damaged.
2
Pull out the door and place it on a soft and
clean surface.
Bottom door
1
Hold the freezer door and remove the two
screws on the middle hinge.
2
Pull the freezer door upwards and place it on
a soft and clean surface.
3
Remove the two blind caps above the
freezer compartment and the blind plug
(if any) on the top of the freezer door and
insert them into the holes on the opposite
sides.
IM_KFK 35411 A2_190318_V04_HR.indb 18
18/3/19 2:03 pm
