5
•
Do not alter or repair supporting and safety-relevant parts (frame, axles etc.).
•
In the case of damage to the appliance, switch it off immediately. Remove the spark
plug cap and have the damage repaired!
•
If the appliance is to be used for mowing crops that are classified as foodstuffs, parts
which come into contact with the foodstuffs must not be lubricated with machine oil
or grease or protected against rust.
•
If there is a danger of slipping on a sloping terrain, an accompanying person must
hold the
2-wheel tractor with a rod or a rope. The accompanying person must
remain above the vehicle at a safe distance from the working tools.
11.
Protective devices
The
2-wheel tractor
is equipped with a
clutch/safety stop lever
on the steering shaft
(left), which disengages the drive via the clutch when released – the engine continues to run. The
drive and the clutch are switched off (see
fig. 2
- page 12).
The clutch/safety stop lever serves as an
emergency stop switch
in dangerous situations where
fast switch-off is required. It swivels automatically into the
‘STOP’
position when released.
It is locked there and can only be actuated when the catch is pressed. Stop the 2-wheel trac-
tor immediately if there are any malfunctions with the clutch/safety stop lever. Have the
malfunction rectified immediately!
Caution!
The engine runs on due to the centrifugal mass!
Tools running on – danger of injury!
•
The
clutch/safety stop lever must be depressed
(operating position) during operation.
•
The clutch/safety stop lever must always be in the Drive OFF position when starting the
machine.
•
It is forbidden by
to leave the clutch/safety stop lever in the start position (cou-
pling/safety stop lever is not depressed) when the machine is to be cleaned – e.g. in order to
clean the snow hoe. First bring the appliance to a halt only by switching off the engine and
then clean the tool.
It is forbidden to disable the safety stop lever by tying or taping it up.
Fig. 2. Safety stop lever – Drive OFF position
Clutch lever
Fig. 3. Safety stop lever – Drive ON position
It is essential to observe the clutch play of
approx. 5 - 10 mm
Adjusting screw
Catch
Clutch/safety stop lever
Drive
OFF
position
Engine continues to run
Clutch/safety stop lever
Drive
ON
position
