(
(
After that, hook in the shift rods as follows:
•
Pull the shift rod for forward and reverse driving (
C
) out of the rubber mount at the bottom
right and feed it in at the top left.
•
Then connect it to the connecting joint on the gearshift lever and secure it with a spring pin.
•
Pull the power take-off shift rod (
B, red
) out of the rubber mount at the top right of the
shaft and feed it into the rubber mount at the bottom left of the shaft.
•
Then connect it to the connecting joint on the power take-off lever (gearbox) and secure it
with a spring pin.
•
Pull the shift rod for the gear shift (
A
) out of the rubber mount at the top left of the shaft
and feed it into the rubber mount at the bottom right of the shaft.
•
Then connect it to the connecting joint for the shift lever (on the gearbox) and secure it with
a spring pin.
Warning!
The gearshift lever on the
2-wheel tractor
type Frästalent Spezial
is fitted with a safety
device. This is to ensure that 4th gear cannot be engaged in the case of rear attachment.
Swivel steering shaft – lateral adjustment
The swivel steering shaft can be swivelled approx. 20° to the left or right from its normal posi-
tion (centre position).
•
Push
lever 2
downwards to the stop, hold it tight and swivel the steering shaft left or right
to the desired position.
•
Move it a little to the left or to the right until you feel the locking bolt latch.
Variable swivel steering shaft (accessory)
-20°
0°
+20°
-20°
180°
+20°
Fig. 20. Swivel steering shaft settings.
