!'
9
6.
General
Watch out for
fuel and oil leaks
and eliminate them if necessary.
Check the tightness of screws, nuts and bolts regularly and retighten them if necessary.
Lubricate all sliding and moving parts (e.g. shifter linkage, Bowden cables etc.) with grease or
oil, especially after cleaning with a high-pressure water jet cleaner!
7.
Attached devices
In the case of
attached devices
not covered by this operating manual, the instructions that came
with the respective attached device must be followed.
8.
Safekeeping and storage
Do not store the
2-wheel tractor:
•
in damp rooms,
•
in rooms in which artificial fertilizer is stored, or
•
in stables or adjacent rooms
as this will lead to
severe corrosion
.
If the tractor is not to be used for a longer period of time,
•
clean it thoroughly
, repair any paint damage and spray bare parts with anti-corrosion oil.
•
Conserve the engine
(change the oil); when doing this, remove the spark plug and pour 1
to 2 teaspoons of motor oil into the spark plug aperture. Turn the engine over slowly sever-
al times. Screw in the spark plug. Turn the engine over until there is compression (valves
are closed). Turn the engine over slowly every 4 - 6 weeks (pull off the spark plug cap be-
forehand).
•
Jack up the
driving wheels
so that the tyres are not resting on the ground. Pneumatic tyres
become unusable in a very short space of time if they are left under load without air in
them.
•
Close the petrol tap if the machine is left to stand for longer periods of time.
